Home Equipment Parts Sovereign Stainless vs Brass Ram Collars

Sovereign Stainless vs Brass Ram Collars

A customer purchased the project sovereign 1 that was listed on the site and asked if I had a replacement ram bolt.  I checked around and I found one of the sov 2 stainless ram bolt collars.

sov_1_ram_bolt

These collars are much more sturdy than the stock Sov 1 collars because they are made (cast? hard to think they could mill these) from stainless or a nice looking steel and position the outer oring slots to the outer edge of the collar.  

On a sovereign 1’s brass collar the exterior orings are positioned right next to the thumb screw slot with ends up deteriorating after a short while. 

In the attached picture you can see the Sovereign 2 stainless collar (new) next to the heavily used Sovereign 1 brass collar that is original to this marker.

Find this post on facebook at:
https://www.facebook.com/photo.php?fbid=418552078238773

Take a second to support Paintball History on Patreon!

LEAVE A REPLY

Please enter your comment!
Please enter your name here

Sovereign to Autococker barrel thread adapter

A neat custom adapter that allows a Sovereign semi auto to take the barrel from an Autococker. Shown on a customized Bad Boyz Toyz Sovereign.

Replacing a stock Nelspot 007 Piercing Pin with a CCI Assembly

Ed "Smiley" Beale's modification for replacing the stock Piercing pin on a Nelson nelspot 007.

FBM Gothic Cocker Body with Tubes

This video offers a closer look at a FBM Gothic Autococker body machined by Chris Ogaz at TnC Products and Ogaz Enterprises.

Peter Clark’s bore drop Maximasters (c.1993?)

Peter Clark ran Peter's Paintball Pursuit Players Products and had Earon Carter of Carter Machine make custom Maximaster pumps for him.

TnC Products’ Rounded Body, prior to the Jackal RDL

Here is a TnC Products' Rounded Blank prior to Jackal RDL (TnC Version).
Take a second to support Paintball History on Patreon!