Home Tech Old School Paintgun Mods Removing a dent from a Stainless RTP Viper Barrel

Removing a dent from a Stainless RTP Viper Barrel

rtp-viper-repaired-barrel
Removed dent from Stainless RTP Viper barrel

Close up on the RTP Viper barrel after the dent was removed.  You can see a few slight marks from the Pex Expander’s teeth.

I should probably perform a Paintball Tek dot com move and sand the teeth off the expander.

Find this post on facebook at:
https://www.facebook.com/photo.php?fbid=397150543712260

Take a second to support Paintball History on Patreon!

LEAVE A REPLY

Please enter your comment!
Please enter your name here

Sovereign to Autococker barrel thread adapter

A neat custom adapter that allows a Sovereign semi auto to take the barrel from an Autococker. Shown on a customized Bad Boyz Toyz Sovereign.

TnC Products / FBM Hinge Frame V2

One of the most outlandish Autococker frames available was without a doubt the second version of the FBM Hinge. This swing frame was machined by Chris Ogaz at TnC Products / Ogaz Enterprises.

PMI 3 with serial in the 500s

A look at a PMI 3 paintball gun that has the matching feed block, side plates and trigger guard. This paintgun is likely from 1990.

Daystate UK’s pumps(c.1985-1991?)

An incomplete history of the Daystate UK pump paintball markers produced in the mid to late 1980s.

Para Ordnance Mod 85 – a Primer Powered Paintball Pistol

A quick look at the Para Ordnance Mod 85 Fully Automatic or Semi Automatic paintball pistol, built in 1985.
Take a second to support Paintball History on Patreon!